How To Use Your Gas Hob - universalblue UECGDWHITE-19 Instruction Manual

3.

HOW TO USE YOUR GAS HOB

The position of the corresponding gas burner is indicated on each control knob.
This appliance can only be used for domestic purposes. In any case it has been
created for comercial or industrial purposes.
GAS BURNER
The burners are different in size and power. Choose the most appropriate one for the
diameter of the cookware being used.
The burner can be regulated with the corresponding control knob by using one of the
following settings:
Some models are equipped with an ignition switch incorporated into the control knob.
If this is the case, the ignitor (D) is present, but not the switch (the
located near each knob).
To light a burner Simply press the corresponding knob and turn it in the counter-
clockwise direction to the High setting, keep press until the burner is lighted.
Caution: If the flame goes out accidentally, turn off the gas with the control knob and
try to light it again at least 1 minute later.
To turn off a burner Turn the knob in the clockwise direction until it is stopped (it
should be on the "." setting).
For safety reasons, it is recommended to close the gas supply if you are not using this
appliance.
RECOMENDATIONS
For best performance, follow these general guidelines:
• Use the appropriate cookware for each burner (see table) in order to prevent the
flame to reach the side of the pot or pan.
• Always use cookware with a flat bottom and keep the lid on.
• When the contents come to a boil, turn the knob to "Low".
The knob must be pressed for about 6 seconds until
the flame is lighted and warmed up.
The "E" ignition button, identified by the
must be pressed first, then the corresponding knob is
pushed and turned in the counter-clockwise direction
to the "High" setting.
symbol,
symbol is
23