Advertisement
Lumination
Product Codes 75521, 75526, 75529, 75541, 96690, 96710, 62186
(Tetra
Contour)
®
BEFORE YOU BEGIN
Read these instructions completely and carefully.
The light guide is made to use together with the light engine.
Please ensure you read the installation guide and
warnings of light engine before installing.
Step 1:
Preparation
Remove the protective film from
1
the light guide.
Silicone Bend-Aid
Fill the entire light guide channel with the GEXNBA Silicone Bend-Aid(s)
4
and press into place. Bend-Aid must be installed prior to heating and
forming. The GEXNBA Silicone Bend-Aid is reusable.
LED Luminaire
®
WARNING / AVERTISSEMENT
Mark the light guide at the
2
required length, adding 0.5 in.
(13mm) for every 16 in. (406mm)
to account for shrinkage during
the forming process.
DO NOT heat and form the light guide
with the light engine installed.
Le guide est conçu pour une utilisation de pair avec un module
DEL Contour. S'assurer de lire les instructions d'installation et les
avertissements avant de procéder à l'installation.
WARNING / AVERTISSEMENT
NE PAS chauffer le guide alors qu'il contient le
module DEL Contour.
Installation Guide
ARCH019
Cut the light guide to the
3
required length using a hacksaw,
chop saw (cross cut or veneer
blade only), band saw, or other
appropriate plastic cutting tool.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Daintree GE Current Lumination Tetra Contour 75521 Series
Summary of Contents for Daintree GE Current Lumination Tetra Contour 75521 Series
- Page 1 Installation Guide ARCH019 Lumination LED Luminaire ® Product Codes 75521, 75526, 75529, 75541, 96690, 96710, 62186 (Tetra Contour) ® BEFORE YOU BEGIN Read these instructions completely and carefully. WARNING / AVERTISSEMENT Le guide est conçu pour une utilisation de pair avec un module The light guide is made to use together with the light engine.
- Page 2 Lumination (Tetra Contour) Installation Guide ® ® Step 2: Heating and Forming For large bends, use either an CAUTION/ATTENTION industrial oven or heating blanket. For small bends, use a heat gun. Avoid direct contact between hot materials and exposed skin or combustibles. Use heat resistant gloves while heating and/ or handling any hot materials.
Need help?
Do you have a question about the GE Current Lumination Tetra Contour 75521 Series and is the answer not in the manual?
Questions and answers