Daintree GE Current Lumination Tetra Contour 62189 Series Installation Manual

Lumination
Product Code: 62189
Description Code: GE180/MV/V24T1-C
(Tetra Contour)
®
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Risk of electrical shock. Disconnect power before
servicing or installing product.
LED Driver Features
• Class 2 wiring per NEC Article 725 (SELV)
• IP54: Dry or damp location rated
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This Class
[A] RFLD complies with the Canadian standard ICES-003. Ce DEFR de la classe [ A ] est conforme á la NMB-003 du Canada.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference at his own expense.
LED Luminaire
®
WARNING / AVERTISSEMENT
Risque de choc électrique. Couper l'alimentation
avant le dépannage ou avant l'installation du produit.
Prepare Electrical Wiring
Electrical Requirements
• The LED driver must be supplied with 100-277 VAC,
50/60 Hz and connected to an individual properly
grounded branch circuit, protected by a 15 or 20
ampere circuit breaker.
Grounding Instructions
• The grounding and bonding of the overall system
shall be done in accordance with National Electric
Code (NEC) Article 600 and local codes.
Installation Guide
ARCH048