Do you have a question about the TD-901T and is the answer not in the manual?
Questions and answers
Moira Homer
March 27, 2025
Machine not blowing very hot it is barely warm what can I do
2 comments:
Mr. Anderson
March 27, 2025
If the Aeolus TD-901T machine is not blowing hot air and is barely warm, check the following:
1. Ensure the heating switch is turned on. 2. Verify that the wind and temperature settings are not set too low. 3. Inspect the heating element assembly (TD-90022) for damage or malfunction. 4. Check the power switch (TD-90030) and heating switch (TD-90027) for proper operation. 5. If the issue persists, discontinue use and have the machine inspected and repaired by a professional. Do not attempt to disassemble it yourself.
This answer is automatically generated
Moira Homer
March 27, 2025
@Mr. Anderson thankyou for responding this is a new purchase and only used twice..haven't had a blast before so it's alien to me I will check it out thankyou
Page 2
Serial No. Item No. Part Name Quantity TD-90001 Rear Cap Fixture Knob TD-90002 M4×10 Screw TD-90003 Washer TD-90004 Rear Cap Rubber Foot TD-90005 Rear Cap TD-90006 M4 Lock Nut TD-90007 Foam Filter TD-90008 Handle TD-90009 M4×12 Screw and Nut TD-90010 Short Housing TD-90011 Housing Rubber Foot...
Page 3
Parameters What makes dryer the best one in the world? Safety Performance MOT1 Our goal at AEOLUS is to ensure that we are the partner of choice for all your requirements in the pet TD-901T Product Name CYCLONE Item Number industry.
Page 4
Wall-mounting Bracket Dryer Stand Carbon Brush Remove the retaining screws on front cap by cross screwdriver in Press the clip down on the connectors of arrow direction, and open the front the wires to motor, unplug the wires and cap. remove the front cap.
Need help?
Do you have a question about the TD-901T and is the answer not in the manual?
Questions and answers
Machine not blowing very hot it is barely warm what can I do
If the Aeolus TD-901T machine is not blowing hot air and is barely warm, check the following:
1. Ensure the heating switch is turned on.
2. Verify that the wind and temperature settings are not set too low.
3. Inspect the heating element assembly (TD-90022) for damage or malfunction.
4. Check the power switch (TD-90030) and heating switch (TD-90027) for proper operation.
5. If the issue persists, discontinue use and have the machine inspected and repaired by a professional. Do not attempt to disassemble it yourself.
This answer is automatically generated
@Mr. Anderson thankyou for responding this is a new purchase and only used twice..haven't had a blast before so it's alien to me I will check it out thankyou