Pioneer PD-F1009 Operating Instructions Manual page 2

WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR M OISTURE.
IM PORTANT
The lightning flash w ith arrow head symbol, w ithin an
equilateral triangle, is intended to alert the user to the
presence of uninsulated "dangerous voltage" w ithin the
product's enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
IM PORTANT SAFETY INSTRUCTIONS
READ INSTRUCTIONS — All the safety and operating
instructions should be read before the product is
operated.
RETAIN INSTRUCTIONS — The safety and operating
instructions should be retained for future reference.
HEED WARNINGS — All w arnings on the product and
in the operating instructions should be adhered to.
FOLLOW INSTRUCTIONS — All operating and use
instructions should be follow ed.
CLEANING — Unplug this product from the w all outlet
before cleaning. The product should be cleaned only
w ith a polishing cloth or a soft dry cloth. Never clean
w ith furniture w ax, benzine, insecticides or other
volatile liquids since they may corrode the cabinet.
ATTACHM ENTS — Do not use attachments not
recommended by the product manufacturer as they
may cause hazards.
WATER AND M OISTURE — Do not use this product
near w ater — for example, near a bathtub, w ash
bow l, kitchen sink, or laundry tub; in a w et basement;
or near a sw imming pool; and the like.
ACCESSORIES — Do not place this product on an
unstable cart, stand, tripod, bracket, or table. The
product may fall, causing serious injury to a child or
adult, and serious damage to the product. Use only
w ith a cart, stand, tripod, bracket, or table
recommended by the manufacturer, or sold w ith
the product. Any mounting of the product should
follow the manufacturer's instructions, and should
use a mounting accessory recommended by the
manufacturer.
CART — A product and cart combination should be
moved w ith care. Quick stops, excessive force, and
uneven surfaces may cause the product and cart
combination to overturn.
VENTILATION — Slots and openings in the cabinet are
provided for ventilation and to ensure reliable
operation of the product and to protect it from
overheating, and these openings must not be
blocked or covered. The openings should never be
blocked by placing the product on a bed, sofa, rug,
or other similar surface. This product should not be
placed in a built-in installation such as a bookcase or
rack unless proper ventilation is provided or the
manufacturer's instructions have been adhered to.
POWER SOURCES — This product should be operated
only from the type of pow er source indicated on the
marking label. If you are not sure of the type of
pow er supply to your home, consult your product
dealer or local pow er company.
LOCATION – The appliance should be installed in a
stable location.
NONUSE PERIODS – The pow er cord of the appliance
should be unplugged from the outlet w hen left un-
used for a long period of time.
CAUTION
• Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation
exposure.
2 • The use of optical instruments w ith this product w ill increase eye hazard.
IM PORTANT NOTICE
The serial number for this equipment is located on the rear panel.
Please w rite this serial number on your enclosed w arranty card and
keep it in a secure area. This is for your security.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT
REM OVE COVER (OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
GROUNDING OR POLARIZATION
÷
If this product is equipped w ith a polarized alternating
current line plug (a plug having one blade w ider than
the other), it w ill fit into the outlet only one w ay. This
is a safety feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If the plug
should still fail to fit, contact your electrician to
replace your obsolete outlet. Do not defeat the
safety purpose of the polarized plug.
÷
If this product is equipped w ith a three-w ire
grounding type plug, a plug having a third (grounding)
pin, it w ill only fit into a grounding type pow er outlet.
This is a safety feature. If you are unable to insert the
plug into the outlet, contact your electrician to
replace your obsolete outlet. Do not defeat the
safety purpose of the grounding type plug.
POWER-CORD PROTECTION — Pow er-supply cords
should be routed so that they are not likely to be
w alked on or pinched by items placed upon or
against them, paying particular attention to cords at
plugs, convenience receptacles, and the point w here
they exit from the product.
OUTDOOR ANTENNA GROUNDING — If an outside
antenna or cable system is connected to the product,
be sure the antenna or cable system is grounded so
as to provide some protection against voltage surges
and built-up static charges. Article 810 of the National
Electrical Code, ANSI/NFPA 70, provides information
w ith regard to proper grounding of the mast and
supporting structure, grounding of the lead-in w ire
to an antenna discharge unit, size of grounding
conductors, location of antenna-discharge unit,
connect ion t o grounding elect rodes, and
requirements for the grounding electrode. See Figure
A.
LIGHTNING — For added protection for this product
during a lightning storm, or w hen it is left unattended
and unused for long periods of time, unplug it from
the w all outlet and disconnect the antenna or cable
system. This w ill prevent damage to the product
due to lightning and pow er-line surges.
POWER LINES — An outside antenna system should
not be located in the vicinity of overhead pow er lines
or other electric light or pow er circuits, or w here it
can fall into such pow er lines or circuits. When
installing an outside antenna system, extreme care
should be taken to keep from touching such pow er
lines or circuits as contact w ith them might be fatal.
OVERLOADING — Do not overload w all outlets,
extension cords, or integral convenience receptacles
as this can result in a risk of fire or electric shock.
ELECTRIC
SERVICE
EQUIPMENT
Fig. A
The exclamation point w ithin an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
OBJECT AND LIQUID ENTRY — Never push objects of
any kind into this product through openings as they
may touch dangerous voltage points or short-out
parts that could result in a fire or electric shock.
Never spill liquid of any kind on the product.
SERVICING — Do not attempt to service this product
yourself as opening or removing covers may expose
you to dangerous voltage or other hazards. Refer all
servicing to qualified service personnel.
DAM AGE REQUIRING SERVICE — Unplug this product
from the w all outlet and refer servicing to qualified
service personnel under the follow ing conditions:
÷
When the pow er-supply cord or plug is damaged.
÷
If liquid has been spilled, or objects have fallen into
the product.
÷
If the product has been exposed to rain or w ater.
÷
If the product does not operate normally by follow ing
the operating instructions. Adjust only those controls
that are covered by the operating instructions as an
improper adjustment of other controls may result in
damage and w ill often require extensive w ork by a
qualified technician to restore the product to its
normal operation.
÷
If the product has been dropped or damaged in any
w ay.
÷
When the product exhibits a distinct change in
performance — this indicates a need for service.
REPLACEM ENT PARTS — When replacement parts
are required, be sure the service technician has used
replacement parts specified by the manufacturer or
have the same characteristics as the original part.
Unauthorized substitutions may result in fire, electric
shock, or other hazards.
SAFETY CHECK — Upon completion of any service or
repairs to this product, ask the service technician to
perform safety checks to determine that the product
is in proper operating condition.
WALL OR CEILING M OUNTING — The product should
not be mounted to a w all or ceiling.
HEAT — The product should be situated aw ay from heat
sources such as radiators, heat registers, stoves, or
other products (including amplifiers) that produce
heat.
ANTENNA
LEAD IN
WIRE
GROUND
CLAM P
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAM PS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
NEC — NATIONAL ELECTRICAL CODE