Advertisement
TS-ENC200 Manual
• Configurable Push Switch: This push switch is readable under software at IO location 192,
bit 0. With JP13 installed, it acts as an on/off power switch to the unit. With JP13
uninstalled, it no longer controls power and its status can be read under software. When
IO location 192 bit 0 is set, then the push switch is in the ON position.
• Side Compact Flash Slot: The TS-5300 and TS-3300 support Compact Flash in IDE mode.
The SBC's Compact Flash connector is accessible from the side of the enclosure.
4 Jumper Settings
The following table explains the meaning of the TS-ENC200 jumpers.
JP #
1
IDE device as Primary (on) or Secondary (off)
2
User Jumper @ read-only I/O 190 bit 1
3
User Jumper @ read-only I/O 191 bit 0
IRQ14,
Selects which IRQ IDE devices uses
IRQ 9,
(Select one only)
IRQ 5
IRQ 9
Selects Which IRQ COM3 uses
IRQ 6
(Select one only)
IRQ 4
IRQ 7
Selects which IRQ COM4 uses
IRQ 5
(Select one only)
IRQ 3
Push Switch Function:
13
On = Push Switch Controls Power
Off = Push Switch now User Push Switch
Table 3 Jumper Settings of the enclosure's interface board
5 Options and other Features
5.1 The TS-ENC200 can be ordered with the following options.
•
Modem:
Optionally, COM4 can be configured as a V.34 33.6Kbaud modem. This
modem uses industry standard AT commands. For a complete list of AT commands,
contact Technologic Systems or visit the downloads page for a PDF.
5.2 Standard Internal Features
•
2.
5" IDE Connector: There is an internal 2.5" IDE ("laptop sized" hard-drives) connector
with mounting support for a any 2.5" hard-drive. The BIOS can handle hard-drives up to
5 Gigabytes in size.
•
3.
5" IDE Connector: There is an internal 3.5" IDE hard-drive connector for a typical PC
sized IDE hard-drive. The BIOS can handle hard-drives up to 5 Gigabytes in size.
Function
7
Technologic Systems
06/01/09
Advertisement
