Advertisement
Quick Links
Advertisement
Related Manuals for Technologic Systems TS-ENC200
Summary of Contents for Technologic Systems TS-ENC200
- Page 1 TS-ENC200 Manual...
- Page 2 Fountain Hills, AZ 85268 480-837-5200 FAX 837-5300 info@embeddedx86.com http://www.embeddedx86.com/ This revision of the manual is dated June, 01 2009 All modifications from previous versions are listed in the appendix. Copyright © 1998-2009 by Technologic Systems, Inc. All rights reserved. 06/01/09...
-
Page 3: Limited Warranty
Technologic Systems Limited Warranty Technologic Systems warrants this product to be free of defects in material and workmanship for a period of one year from date of purchase. During this warranty period Technologic Systems will repair or replace the defective unit in accordance with the following instructions: •... -
Page 4: Table Of Contents
TS-ENC200 Manual Technologic Systems Table Of Contents Limited Warranty........................ 3 Introduction......................... 5 Standard Headers and Connectors ................5 Dimensions ......................... 8 Appendix A Enclosure Visuals................... 8 Appendix B - Manual Revisions..................8 06/01/09... -
Page 5: Introduction
Technologic Systems 1 Introduction The Technologic System’s metal enclosure(TS-ENC200) is made to hold two cards: a Technologic System’s PC/104 Embedded Personal Computer (EPC), and an “interface” board. The EPC is PC/104 form factor, which could allow any PC/104 board to be used within the metal enclosure. - Page 6 TS-ENC200 Manual Technologic Systems • COM 2: COM2 is brought in from the base SBC. This RJ-45 connectors use the pin-outs established by the EIA/TIA 561 specification for RS-232. The TxD, RxD, RTS, CTS, and ground pins are supported for RS-232 communications.
- Page 7 • Side Compact Flash Slot: The TS-5300 and TS-3300 support Compact Flash in IDE mode. The SBC’s Compact Flash connector is accessible from the side of the enclosure. 4 Jumper Settings The following table explains the meaning of the TS-ENC200 jumpers. JP # Function...
-
Page 8: Dimensions
The previous section details the pin assignments of the COM1 and COM2 RJ-45 connectors (see figures 1 and 2). Technologic Systems can provide a cable to connect directly to a P.C.’s com port. See your EPC’s manual for more details on how to communicate with the EPC.