Advertisement
Note: If the parameter you highlight and drag & drop into the Mini control can be programmed
into the Mini – that Mini control function will turn bright green as you approach it to drop the
control parameter into it. If it displays bright red - it cannot be programmed into that position.
Next - position your cursor over the Input #1 Mute. Highlight & Capture it in the same
manner and after release - drag and drop the highlighted Mute function onto Button #1 of
the Mini S4K1 wall control.
Continue to further program the balance of the Mini S4K1 control buttons (and any other Mini
controls you drag and drop into the Project View work area) to satisfy your control needs
using any viable parameter function from any DSP module & preset in your DSP design.
You have now successfully programmed two separate DSP parameter control
functions into the Mini S4K1 wall control. Input #1's Fader Level and Mute Control
functions. As shown below - Both are now light red in color to indicate that they have been
programmed and the Mini wall controls 3 remaining On/Off buttons remain light green in color
as indicated – ready to be programmed (with other Switch and Preset control functions).
18. Save Project:
Click the "Save Project" Disc located to the right of the zoom control in the Project View
work area to "Save" your Mini control programming and the DSP design project work to your
PC. Each time any programming or DSP adjustment is made the Save Project Disc will re-
appear. OR - Select "Save Project As" or "Save Project" under the File menu at the top
left of the Project View page to save your work.
Note:
This saves the Mini programming (and DSP design) you are working on to your
PC/Computer but not to the physical Mini device (or processor device) itself. See
"Switch to Online Mode" below to save your work to the physical Mini and processor
devices.
Note:
We recommend that you Save As the project file twice. Once to create a Master File
and a second time to create a Work File. Continue working with the Work File, update the
Master File appropriately and the Master File is protected. At the end of the project –
continue running the system with the Work File, rename it to Master Ver 2, or other.
NeuPanel-Mini Series
XILICA AUDIO DESIGN CANADA / ASIA / EUROPE
Quick Start Guide
Page | 15
Advertisement
