Headset Installation - ChatterBox FRS X2 Owner's Manual

Headset Installation

1. For the open face headset, use the plastic tie clip to secure the
windsock. For the full face headset, microphone covers come pre-
installed.
2. Helmets without speaker pockets. Attach the foam covers to the
speakers respectively (Drawing 1). Attach the hard velcro disk to
the back of the speakers (Drawing 2). Attach the soft velcro disks
to the helmet liner. The position of the soft velcro disks will deter-
mine the position of the speakers.
1 2
3. Attach the right speaker (the long cord) to the soft velcro disk
that you applied to the helmet liner. Attach the left speaker (the
short cord) to the soft velcro disk that you applied to the helmet
liner. For helmets with speaker pockets, simply insert the speaker
in the pocket. Then use the wooden stick to gently tuck the speak-
er wire between the headliner and the shell (Drawing 3).
4
3
4. For full face headset. Attach the soft rectangular velcro piece to
the chin bar. Keep in mind the position of this velcro will deter-
mine the position of the mic. Apply the mic to the soft rectangular
velcro. Then use the wooden stick to gently tuck the mic wire
between the headliner and the shell (Drawing 4).
13