Advertisement
4. Connect the pressurised-air hose of your compressor to the pressurised-air connector of the
white paint spray gun. Make sure that the valve is closed.
5. Fill the medium to be sprayed into the hopper.
6. Adjust the compressor to approx. 3.4 bar. If necessary, you may increase the pressure later to
a maximum value of 4.8 bar.
7. Adjust the flow rate with the help of the dosing screw at the rear part of the spray gun.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Attention!
Do not fill the hopper to overflowing.
Item 61304
Page 4
12 2021-1
Advertisement
