Table of Contents
Advertisement
PARTS
The following replacement parts and accessories are available
for the TM Series meters:
Part No.
Description
12517601
Gasket
12518701
Adapter
125518-01 3 in. (Spigot) Turbine Assy Kit
125518-02 3 in. (NPT) Turbine Assy Kit
125518-03 3 in. (Flange) Turbine Assy Kit
125520-01 4 in. (Spigot) Turbine Assy Kit
125520-02 4 in. (NPT) Turbine Assy Kit
125520-03 4 in. (Flange) Turbine Assy Kit
G G M O D E L
IMPORTANT NOTICE
This manual will assist you in operating and maintaining the GPI
electronics supplied with your GPI meter. The GPI Electronics
can be used in indoor or outdoor applications where occasional
exposure to moisture is common.
The GG Model Pulse Out with Display can be battery powered
(9-volt supplied) or externally powered.
SAFETY INSTRUCTIONS
• This product is not approved for use in hazardous locations.
• Be sure O-rings and seals are kept in good repair.
• When applying power, use DC power only!
• Disconnect external power before attaching or detaching
input or output wires.
INSTALLATION
CAUTION
Installation should be performed only by qualified
personnel, and in accordance with local governing
regulations.
Avoid plumbing meter where the Display is:
• Subject to constant exposure to water or other liquids (oc-
casional low-pressure splashing will not harm unit).
• Subject to >5g shock loading.
• Facing the sun directly for long periods of time.
The GG Model is shipped without cable or strain relief. See Illus-
trated Parts List for these components. When wiring long lengths
of cable, be sure to connect the shield to LOCAL-COM only!
(Multiple shield connections may cause ground-loop problems.
Try to keep cable lengths short. Individual installation sites vary
widely, contact GPI Customer Service with questions regarding
your specific needs.
3
Advertisement
Table of Contents
