Download Print this page

Omegawave COACH Quick Start Manual

Hide thumbs Also See for COACH:

Quick Start Guide for Testing on COACH

Open Omegawave App.



Have the athlete to be measured to put on all equipment:



Thoroughly wet both ECG pads on the chest strap, then put on



Attach 2 electrodes—one in the center of the forehead, the other on the base of



the dominant thumb

Connect the CNS cables to the electrodes, and then attach the cables to the sen-



sor

Connect the sensor to the chest strap and check that the Omegawave logo is not



upside-down relative to the athlete's head & shoulders

Have the athlete lie down and remain still during testing.



Make sure the iPad's Bluetooth is on, the volume is turned up, the device is connect-



ed to a WiFi network or cellular data, and that the Omegawave sensor is paired to

the app (If you cannot find the sensor in the Omegawave App, check to make sure it

is not paired in the iPad's Bluetooth settings—it will be listed as "OW-CB2").

(See back for picture)

Table of Contents

Do you have a question about the COACH and is the answer not in the manual?

Page 1 WiFi network or cellular data, and that the Omegawave sensor is paired to the app (If you cannot find the sensor in the Omegawave App, check to make sure it is not paired in the iPad’s Bluetooth settings—it will be listed as “OW-CB2”).
Page 2 Quick Start Guide for Testing on COACH Select the athlete to be tested.  Press ‘Measure’ at the top of the screen.  The green “Start measuring” button will light up and  become active once the app detects a pulse and CNS data.