Modal Electronics Cobalt 5S User Manual page 9

UI Combinations
Quick Recalls
COBALT5S has 4 Quick Recall slots for quickly loading presets. Quick Recalls are controlled
using the following button combos:
• Hold 'Patch' + hold one of the four encoder switches to the left of the panel to assign the
currently loaded patch to a QR slot
• Hold 'Patch' + press one of the four encoder switches to the left of the panel to load the
patch in the QR slot.
LFO
• Turn the 'Rate' encoders into the negative range to access synced rates.
Filter
• Hold the 'Patch' switch and turn the 'Cutoff' encoder to control the Filter Type parameter.
Envelopes
• Press either the 'F', 'A' or 'M' switch for the ADSR and Depth controls to adjust the
envelope parameters.
• Hold either the 'F', 'A', or 'M' switch for one second and then turn the ADSR encoders to
adjust all envelopes simultaneously .
Sequencer
• Hold 'Patch '+ 'Play' switches to clear the sequencer notes .
• Hold the 'Patch' switch and press the 'Record' switch to enter the Step Sequencer 'Edit'
Mode, if the currently loaded sequence is in 'Step' mode.
• When the screen is displaying the 'Linked Sequence' parameter, hold the 'Edit' switch to
set the value to be the currently loaded sequence.
16
UI Combinations
Arp
• Hold the 'Arp' switch, and press keys on the internal or an external keyboard to add
pattern notes or press the 'Edit' switch to add a rest to the pattern.
• Hold the 'Patch' switch and turn the 'Division' encoder to control Arp Gate.
Keyboard/Voice
• Hold the 'Patch' switch and press the 'Mix' encoder switch to cycle through the different
Voice Modes.
• Hold the 'Patch' switch and turn the 'Mix' encoder to control the Glide parameter.
• Hold the 'Mod' + 'Oct-' buttons and press a key on the internal keyboard to transpose
all notes, where the central C key is the root note. Press these buttons with no keyboard
interaction to reset the transpose value back to 0.
• Hold the 'Oct-' + 'Oct+' buttons for one second when turning on Sustain to enable
Sustain 'Latch Mode'.
Modulation
• To assign a Mod Slot hold the 'Mod' button and press the desired Mod source switch
(labelled with grey boxes on the panel) so that the relevant blue LED is flashing; then set a
depth by turning the desired modulation destination parameter encoder.
• When latched in a Mod Source assign mode, pressing the 'Mod' button again will exit
mod assign mode.
• Press the 'Mod' button repeatedly without selecting a mod source switch to cycle through
and view all mod slot settings on the screen.
• When the screen is displaying a mod slot 'Depth' parameter (most easily accessed via the
'Mod' button), hold the 'Edit' switch to clear the mod slot assignment.
• To assign a mod source to the Global Pitch destination, use the 'OscDrift' control. 'Tune1'
will assign to Osc1 Pitch, 'Tune2' will assign to Osc2 Pitch.
17