To Gain Access Inside The Air Curtain - Mitsubishi Electric Thermoscreens VRF HP Installation, Operation & Maintenance Instructions Manual

To gain access inside the Air Curtain

To gain access for connection of the electrical supply, controls wiring
and to work on the unit during commissioning, remove the air inlet
grilles and the bottom access panel.
First remove the plastic end caps at each end of the unit, if already
fitted, by pulling off to the side (see picture).
Then remove each inlet grille in turn with its filter by unfastening
the quarter-turn Philips Head fastener at the bottom corner of the
grille. Use a Philips No.1 screwdriver to access the screw via the
elongated hole at the bottom corner of each grille and turn anti-
clockwise to remove (see picture).
To remove the bottom access panel unfasten the access panel
securing screws, one at each end, plus two in the centre (VRF
HP1500 DXE and VRF HP2000 DXE units) and slide the panel
out forwards (see picture).
access panel
screw
Please note: All the panels of the air curtain are covered in a protective plastic film
which should now be removed.
T9901075-2-3 UK Page 14 of 38