Hitachi C43-FD5000 Service Manual page 29

SERVICE ADJUSTMENTS
2) If the Adjustment point is not on center, by press cursor key on R/C, then Convergence Data of all of
one line include existing Adjustment Point Marker are exchanged at the same time.
ex) Fig.5 (Fig.6) : By press [↑] ([←]) key on R/C, move up
(left) RED convergence data of all of horizontal (vertical)
line include existing Adjustment Point Marker.
c) Press [SUB] key on R/C again to exit RATER POSITION ADJUSTMENT MODE.
Adjustment point
Extra horizontal line
NOTE: PAL mode can be confirmed by extra horizontal lines.
All manuals and user guides at all-guides.com
Adjustment point (NTSC 60p mode)
Adjustment point (PAL 50p,PAL 100i mode)
29
Adjustment point
9 x 13 = 117 point
Adjustment point
9 x 13 = 117 point