Vertical Size Adjustment - Hitachi C43-FD5000 Service Manual

SERVICE ADJUSTMENTS
2.7

VERTICAL SIZE ADJUSTMENT

Adjustment Preparation
(1) VIDEO control should be set to Factory Preset condition.
(2) DCU ROM CHECK should be completed.
(3) Place the set facing east.
Adjustment Procedure
PAL 100i MODE
(1) Input any PAL signal.
(2) Press [MENU] key.
(3) Choose FUNCTION and SCAN, and set to 100Hz mode.
(4) Press [MENU] key to exit from FUNCTION.
(5) Press and hold the SERVICE ONLY SW. on CONV./FOCUS P.W.B. and [MUTE] key of Handset.
Green DCU cross-hatch are appeared with Conv. Data cleared.
(6) Press the input selector, then SERVICE MENU appears.
(7) Choose V.SIZE (amplitude) item by using Handset up/down cursor key.
(8) Adjust V.SIZE (amplitude) as following by using Handset left/right cursor key.
So that the distance between the topmost horizontal line and the bottommost horizontal line of DCU's
cross-hatch pattern is L.
(9) Press [MUTE] key of handset to write the data.
(10) After adjustment, press SERVICE ONLY SW. for exit from SERVICE mode.
PAL 50Hz PROGRESSIVE MODE
(1) Input any PAL signal.
(2) Press [MENU] key.
(3) Choose FUNCTION and SCAN, and set to Progressive mode.
(4) Press [MENU] key to exit from FUNCTION.
(5) Adjust the same items as (5)-(10) of setting PAL 100i MODE.
NTSC 60Hz PROGRESSIVE MODE
(1) Input any NTSC signal.
(2) Adjust the same items as (5)-(10) of setting PAL 100i MODE.
L PAL 100i mode
43" 525
50" 610
All manuals and user guides at all-guides.com
2
I C No.13
2
I C No.17
2
I C No.21
Tolerance: ±5mm
Unit: mm
PAL 50p mode NTSC 60p mode
525 560
610 650
18
The distance between the topmost
horizontal line and the bottommost
horizontal line
L