Flash F7100549 User Manual page 4

User Manual • Instrukcja Obsługi
5.2 Voltage specification
Input Voltage
220V
5.3 Connecting power supply
The connection is performed using
power cable with PowerCon connector
( i n c l u d e d ) . T h e d e v i c e m u s t b e
operated by qualified personnel.
Total Power
CAUTION! In the case of cable damage do not attempt to repair.
Replacement or repair can be made only on the manufacturer or by a
person with appropriate permissions.
Using lamp, the change rate of power voltage should be within
± 10%, if the voltage is too high, it will shorten the light's life; if it's not
enough, the lamp will be dark. Please restart it after turning off light
for 20 minutes until full-cooling. Frequent switching will reduce the
life span of lamps and bulbs; intermittent using will improve the life
of bulbs and lamps.
80W
Make sure that the power grid supply
parameters are consistent with device
parameters and limitations are not
exceeded.
Frequency
50/60Hz