Safety Information - Flash F7100549 User Manual

User Manual • Instrukcja Obsługi
1. INTRODUCTION
THANK YOU FOR PURCHASING Moving Head 60W Spot. FOR SAFETY REASONS AND TO
ENSURE THE TROUBLE-FREE OPERATION, CAREFULLY READ THE INSTRUCTIONS.

2. SAFETY INFORMATION

• Please keep this User Manual for future
consultation. If you sell the fixture to another
user, be sure that they also receive this
instruction booklet.
• Unpack and check carefully there is no
transportation damage before using the
fixture.
• Before operating, ensure that the voltage
and frequency of power supply match the
power requirements of the fixture.
• It's important to ground the yellow/green
conductor to earth in order to avoid electric
shock.
• Disconnect main power before servicing
and maintenance.
• Use safety chain when fixes this fixture.
Don't handle the fixture by taking its head only,
but always by taking its base.
WARNING! The Moving Head 60W Spot has a powerful pan motor. The torque reaction when the
head is panned suddenly can cause the base to move if the fixture is standing unsecured on a
surface. Do not apply power to the Moving Head 60W Spot unless the baase is securely fastened
to a surface or to rigging hardware.
WARNING! Use 2 clamps to rig the fixture. Do not hang the fixture from only one clamp. Lock
each clamp with both 1/4-turn fasteners. Fasteners are locked only when turned a full 900
clockwise.
WARNING! When clamping the fixture to a truss or other structure at any other angle than with
the yoke hanging vertically downwards, use two clamps of half-coupler type. Do not use any type
of clamp that does not completely encircle the structure when fastened.
WARNING! Position or shade the head so that the front lens will not be exposed to sunlight or
any other strong light source from any angle - even for a few seconds. See Figure 2. The Moving
Head 60W Spot lens can focused the sun's rays, creating a potential fire hazard and causing
damage.
IMPORTANT! Do not point strong light output from other fixtures at the Moving Head 60W Spot,
as intense illumination can damaged the display.
Figure 2. Lenses can focused sunlight and strong light, presenting a risk of fire and damage to the fixture.
• Maximum ambient temperature is: 400C
Don't operate it where the temperature is
higher than this.
• In the event of serious operating problem,
stop using the fixture immediately. Never
try to repair the fixture by yourself. Repairs
carried out by unskilled people can lead to
damage or malfunction. Please contact the
nearest authorized technical assistance
center. Always use the same type spare parts.
• Do not connect the device to any dimmer
pack.
• Do not touch any wire during operation and
there might be a hazard of electric shock.
• To prevent or reduce the risk of electrical
shock or fire, do not expose the fixture to rain
or moisture.
• The housing must be replaced if they are
visibly damaged.
• Do not look directly at the LED light spot
while the fixture is on.
W A R N I N G !
Shield or shade the head if necessary.