Advertisement
Quick Links
Advertisement
Related Manuals for D-CUT Silverise Series
Summary of Contents for D-CUT Silverise Series
- Page 1 SERIES Operation Manual D-Cut TD-080 Wet Tile Saw...
-
Page 2: For Your Safety
Do not use the saw when the blade is not installed properly. Always switch off the saw before lifting the table for cleaning. Only use original D-Cut accessories. Never leave the saw running unattended. Keep guards in place. Adhere to safety guidelines: (ANSI) American Safety Standards Institute. - Page 3 INNOVATION PUT TO WORK Here at D Cut Products, Inc. We are always looking to come out with new innovative products. Check out Our Website for Updates at www.dcutproducts.com or contact us at sales@dcutproducts.com The serial number of your saw is located on the left side above the switch.
- Page 5 Contents in the Box: Fig.1 Warranty (1) Continuous rim card diamond blade, (2) 45 degree attachments, (1) wrench set, (1) operation manual and Warranty card. Installation of the Blade Open the “Open/Close cover” and use provided the wrench to install the provided blade.
- Page 6 Fill Water Fig.4 Open the “Open/ Close cover” then pour water into the tray. Water can be added or refilled as needed during saw operation Water Level Limit The plug for the water tray shown in Fig.5 is also a water level control device.
- Page 7 Table Lock/Unlock Lever Fig.7 Unlock the table as shown in Fig.7 before moving the table. Placing a Tile on the Table Fig.8 Place a tile on the moving table, flush against the table back shown in Fig.8. And then turn on the motor.
- Page 8 Attachment Use the attachment shown in Fig.10 as a limitation stopper when repeatedly cutting same size of the tile. Warning: Remove this attachment from the table when not needed. Fig.10 0-90 Degree Attachment Unlock the screw o n the attachment shown in Fig.11 and set it to the proper angle between 0-90 degrees, then lock the...
- Page 9 Drain the Water Fig.13 Open the top cover right above the water plug shown in Fig.13 and pull the plug. Cleaning the Saw Pour a bucket of clean water from the “Open/ Close cover” throughout the water tray and use the provided scraper to clean and remove the cutting debris and slurry...
- Page 11 TD-080 Parts List Parts Description Q'ty Parts Description Q'ty Table assembly Small pulley Screw M4 Large pulley Hex nut M4 Shaft ring 12mm Open Ring 4mm Water Tank Seal spacer 6mm Roller on supporting frame Pin for roller Flat spacer 6mm Support frame Inner water stopper Water tank cover...
- Page 12 Trouble shooting: 1 No t cutting straight . Check bla de to make sure it’ n ti . Make sure w orking piece is flush against table back (Fig. tor doesn’t work . Check power source co . Check powe r cords for da ma e.