Table of Contents
Advertisement
CONNECTIONS
Things to Know Before
Connecting Components
Protect Your Components from Power Surges
•
Connect all components before plugging any power
cords into the wall outlet.
•
Always turn off the TV and other components before you
connect or disconnect any cables.
Position Cables Correctly to Avoid Audio Hum or
Interference
•
Insert all cable plugs firmly into their jacks.
•
Place the audio/video cables to the sides of the TV's back
panel instead of straight down the middle after you
connect your components.
•
Try not to coil any twin-lead cables and keep them away
from the audio/video cables as much as possible.
•
Make sure all antennas and cables are properly
grounded. Refer to the Safety Tips sheet packed with
your unit.
Protect Your Components from Overheating
•
Do not block ventilation holes in any of the components.
Arrange the components so that air can circulate freely.
•
Do not stack components.
•
Allow adequate ventilation when placing your
components in a stand.
•
Place an amplifier or satellite receiver on the top shelf of
the stand so heated air rising from it will not flow around
other components.
1
FIRST THINGS FIRST
2
SETTING UP THE VCR
3
VCR BASICS
4
RECORDING
5
OTHER FEATURES
5
6
7
CONNECTIONS
39
Advertisement
Table of Contents
