Outdoor Uint Wiring - Airwell CDMX-035N-09M25 User & Installation Manual

Indoor unit power wires
Outdoor unit
Indoor & Outdoor
connective wires
(purchased seperately)
(C)
Air switch
(purchased seperately)
Indoor unit power wires
Outdoor unit power wires
Outdoor unit
Indoor & Outdoor
connective wires
(purchased seperately)
(D)
(Only for the North America)
Air switch
(purchased seperately)
Outdoor unit power wires
Outdoor unit
Air switch
(purchased seperately)
NOTE: The cographs are for explanation
purpose only. Your machine may be
slightly di erent. The actual shape shall
prevail.
Page 36
 
Outdoor Unit Wiring
Air switch
(purchased seperately)
Before performing any electrical or wiring
work, turn o the main power to the
system.
Indoor unit
1. Prepare the cable for connection
NOTE: In North America, choose the cable
type according to the local electrical codes
and regulations.
Minimum Cross-Sectional Area of
Air switch
Power and Signal Cables (For reference)
(purchased seperately)
Indoor unit
CHOOSE THE RIGHT CABLE SIZE
The size of the power supply cable, signal
cable, fuse, and switch needed is determined
by the maximum current of the unit. The
Indoor & Outdoor
connective wires
maximum current is indicated on the nameplate
(purchased seperately)
located on the side panel of the unit. Refer to
this nameplate to choose the right cable, fuse,
or switch.
Indoor unit
NOTE: In North America, please choose the
right cable size according to the Minimum
Circuit Ampacity indicated on the nameplate
of the unit.
NOTE: When connecting the wires,
strictly follow the wiring diagram found
inside the electrical box cover.
WARNING
a. You must rst choose the right cable
size. Be sure to use H07RN-F cables.
Rated Current of
Nominal Cross-Sectional
Appliance (A)
> 3 and ≤ 6
> 6 and ≤ 10
> 10 and ≤ 16
> 16 and ≤ 25
> 25 and ≤ 32
> 32 and ≤ 40
b. Using wire strippers, strip the rubber
jacketfrom both ends of the signal cable
to reveal approximately 15cm (5.9") of wire.
c. Strip the insulation from the ends.
d. Using a wire crimper, crimp u-lugs on the
ends.
Area (mm²)
0.75
1
1.5
2.5
4
6