Page 1
41218 MR 12 X 18 SOLARIUM ASSEMBLY INSTRUCTIONS Three adults required for assembly Base Dimensions 12’ ½”x18’11” Largest Dimensions 13’6”x20’4½” Overall Height 110’’ L:\WP51\INSTRUCTIONS\SOLARIUMS INSTRUCTION BOOKS\41218 MR\ZZZ-184.41218MR.0926-16.GP.EN.doc SUN-HP...
Page 2
#2 Phillips screwdriver (supplied) Rubber mallet Based on the location, decide where you would like to position the two (2) doors panels which can slide open to the left or the right, your choice. L:\WP51\INSTRUCTIONS\SOLARIUMS INSTRUCTION BOOKS\41218 MR\ZZZ-184.41218MR.0926-16.GP.EN.doc SUN-HP...
Page 3
(E) to affix the panel and door frame. When assembling angled panels (A1), you should put the two panels at 135 degree angle then use the angled connecting pieces (I) and (J) to affix the panels together. L:\WP51\INSTRUCTIONS\SOLARIUMS INSTRUCTION BOOKS\41218 MR\ZZZ-184.41218MR.0926-16.GP.EN.doc SUN-HP...
Page 4
1. Slide top door rail (F) into wheels of sliding door. 2. Slide lower door rail (G) into the plastic guide of the sliding door (B1). 3. Use bold (Bb) to affix the plastic stoppers (H) one on each end of top door rail (F). L:\WP51\INSTRUCTIONS\SOLARIUMS INSTRUCTION BOOKS\41218 MR\ZZZ-184.41218MR.0926-16.GP.EN.doc SUN-HP...
Page 5
2. Secure the bottom door rail (G), using a bolt (Cc) with a washer (Gg). 3. Paying careful attention to whether it is the left (Dd-L) or right (Dd-R) latch, use bolt (Bb) to affix the door latch onto the frame. L:\WP51\INSTRUCTIONS\SOLARIUMS INSTRUCTION BOOKS\41218 MR\ZZZ-184.41218MR.0926-16.GP.EN.doc SUN-HP...
Page 6
Attach roof rafters (L2) to the central hub (J1) using bolt (Bb). Use screw (Z) to affix the rafters (L2) onto the top of panels going through the metal piece attached to the rafter (L2). L:\WP51\INSTRUCTIONS\SOLARIUMS INSTRUCTION BOOKS\41218 MR\ZZZ-184.41218MR.0926-16.GP.EN.doc SUN-HP...
Page 7
Use the same method to assemble roof rafters (L1) for the angled panels. The rafters (L1) should be affixed to the mounting bracket using the hole that will be furthest away from the corner of the unit. L:\WP51\INSTRUCTIONS\SOLARIUMS INSTRUCTION BOOKS\41218 MR\ZZZ-184.41218MR.0926-16.GP.EN.doc SUN-HP...
Page 8
Step 6: Use nut (Hh) and washer (Gg) to affix the top cap (K1) to the central hub (J1). L:\WP51\INSTRUCTIONS\SOLARIUMS INSTRUCTION BOOKS\41218 MR\ZZZ-184.41218MR.0926-16.GP.EN.doc SUN-HP...
Page 9
(S1) at your starting point and place a finishing end (Q) then re-install the screw (S1). Note: the finishing ends change depending on where you are along the unit. Always refer to the illustration. L:\WP51\INSTRUCTIONS\SOLARIUMS INSTRUCTION BOOKS\41218 MR\ZZZ-184.41218MR.0926-16.GP.EN.doc SUN-HP...
Page 10
From the inside of the solarium, install the solidifying bar (N and N1) as illustrated using the screws (V). Each screw (V) must be inserted into two pre-drilled holes prior to be screwed to the roof bars. L:\WP51\INSTRUCTIONS\SOLARIUMS INSTRUCTION BOOKS\41218 MR\ZZZ-184.41218MR.0926-16.GP.EN.doc SUN-HP...
Page 12
Step 10 : After the installation on the upper roof panels, install the bottom roof panels (Rr, R1b, Qb, Qc, Rb) according to below drawings. L:\WP51\INSTRUCTIONS\SOLARIUMS INSTRUCTION BOOKS\41218 MR\ZZZ-184.41218MR.0926-16.GP.EN.doc SUN-HP...
Page 13
Step 11: Once the installation of the panels is complete, screw cover roof bars (O/O1) to the roof bars (L1/L2) with screw (U). L:\WP51\INSTRUCTIONS\SOLARIUMS INSTRUCTION BOOKS\41218 MR\ZZZ-184.41218MR.0926-16.GP.EN.doc SUN-HP...
Page 19
4. The product is not warranted in the event it has been improperly anchored. 5. We reserve the right to replace or repair any defective product or parts at our discretion. L:\WP51\INSTRUCTIONS\SOLARIUMS INSTRUCTION BOOKS\41218 MR\ZZZ-184.41218MR.0926-16.GP.EN.doc SUN-HP...