Changing The Snap Setting; Setting The Project Volume - Zoom R20 Operation Manual

Changing the snap setting

The snap setting used for the entire project can be changed.
If this is "On", notes and regions will be aligned to ruler increments when moved (→
1.
On the Project Settings Screen, tap "On" or "Off" for "Snap".
Setting
Off
On

Setting the project volume

Use this to adjust the project volume for output from the OUTPUT jacks.
1.
Slide the Output Level slider or tap
The set volume is shown above the slider.
NOTE:
This can be set from 0 to 100.
This turns off the snap function.
This turns on the snap function.
and on the Project Settings Screen.
42
Control Bar
Explanation
overview).