Summary of Contents for Flight Display Systems FD171DMT HDSDI-CAN
Page 1
Page 1 of 15 FD171DMT ver HDSDI-CAN Installation and Operation Manual 17.1” LCD and Display Mount Manufactured by MILIC, LLC with marketing support from Flight Display Systems. This product does not have FAA PMA approval. TECHNICAL SUPPORT +1 (678) 867-6717, or...
All manuals and user guides at all-guides.com Rev: Revision Date: 04/22/21013 MAN – FD171DMT ver HDSDI-CAN Page 3 of 15 Table of Contents General Information ........................4 1. Front View ..........................4 2. Side View ..........................4 Additional Information ......................5 Specifications ..........................5 Installation Instructions ......................6 Power ..............................6 Wiring Suggestions ........................6 Power and Ground Wiring ......................7...
All manuals and user guides at all-guides.com Rev: Revision Date: 04/22/21013 MAN – FD171DMT ver HDSDI-CAN Page 4 of 15 General Information The FD171DMT ver HDSDI-CAN is a 17.1" LCD and Display Mount which has features that allow installation in the smallest of mounting areas with the minimum of interface equipment.
Additional Information The FD171CV-LP, is an integral part of the FD171DMT. The video source input for the FD171DMT is currently HDSDI-CAN. Contact Flight Display Systems for other video input options. The FD171DMT ver HDSDI-CAN is not visible to passengers while stored, but can be swung out and into the aisle for accessible viewing.
All manuals and user guides at all-guides.com Rev: Revision Date: 04/22/21013 MAN – FD171DMT ver HDSDI-CAN Page 6 of 15 Installation Instructions All cabin entertainment equipment, such as the FD171DMT ver HDSDI-CAN, should be installed on a non-essential bus and have a dedicated circuit breaker. The FD171DMT ver HDSDI-CAN is integrated with a rugged mounting bracket.
All manuals and user guides at all-guides.com Rev: Revision Date: 04/22/21013 MAN – FD171DMT ver HDSDI-CAN Page 7 of 15 Power and Ground Wiring This is a 28 VDC monitor that requires 1.3 Amp of power to operate. To operate properly this monitor requires an input voltage of 18-29 VDC.
All manuals and user guides at all-guides.com Rev: Revision Date: 04/22/21013 MAN – FD171DMT ver HDSDI-CAN Page 8 of 15 Power/Video Pin out for P1 (5W1 Combo-D Female Receptacle) Supplied Connector P/N: Conec – 3005W1SM99A10X Coax Contact P/N: Conec – 132J30029X (for use with RG179)* *Other cable type contacts available from Conec MATING FACE Description...
All manuals and user guides at all-guides.com Rev: Revision Date: 04/22/21013 MAN – FD171DMT ver HDSDI-CAN Page 11 of 15 Operation Instructions When deployed, the FD171DMT ver HDSDI-CAN is continuously on but can be de- energized by removing power from the entertainment system. No pilot or aircrew action is necessary during flight or ground operation.
All manuals and user guides at all-guides.com Rev: Revision Date: 04/22/21013 MAN – FD171DMT ver HDSDI-CAN Page 12 of 15 Remote Control Multi-Unit Remote – button functionality may vary.
All manuals and user guides at all-guides.com Rev: Revision Date: 04/22/21013 MAN – FD171DMT ver HDSDI-CAN Page 13 of 15 Troubleshooting Video Noise Check for an incorrect ground in the installation wiring. See specific examples of video noise below, or visit http://FlightDisplay.com/Grounding.pdf Snow or Sweeping Lines Lines that slowly sweep up and down are a result of AC noise.
Technical Support Should you have any questions concerning this product or other Flight Display Systems products, please contact our Product Support representatives at (678) 867-6717. Flight Display Systems 1765 Grassland Parkway Alpharetta, GA 30004 Phone: +1 (678) 867-6717 Fax: +1 (678) 867-6742 Email: sales@FlightDisplay.com...
6717 to obtain assistance. If the return of the unit to the factory is required, an RMA number will be issued at that time. Flight Display Systems will, upon receipt of the failed hardware, remanufacture or replace the unit at our discretion.