Advertisement
HittingStation # 1
TM
MODEL# HS4999
Rev. Date: 09/2017
INSTRUCTIONS
IMPORTANT
DO NOT RETURN THIS PRODUCT TO THE RETAIL STORE WHERE
PURCHASED. CALL TOLL FREE: (800) 492-9334
WARNING:
Improper use of this product can result in serious injury. Read and follow full instructions for
the proper and safe use of the HittingStation #1. Always wear a helmet with a guard. Adult
supervision is required. Inspect all aspects of the product before each use for evidence
of damage. If damaged, DO NOT USE, call our toll free number for replacement parts.
Keep area clear in front of tee and around the swinging area of the batter.
®
95 West 650 South • St. George, UT 84770 • Toll Free: (800) 492-9334 • CustomerService@HeaterSports.com
page 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Heater Sports HittingStation 1
Summary of Contents for Heater Sports HittingStation 1
- Page 1 HittingStation # 1 MODEL# HS4999 Rev. Date: 09/2017 INSTRUCTIONS IMPORTANT DO NOT RETURN THIS PRODUCT TO THE RETAIL STORE WHERE PURCHASED. CALL TOLL FREE: (800) 492-9334 WARNING: Improper use of this product can result in serious injury. Read and follow full instructions for the proper and safe use of the HittingStation #1.
- Page 2 PARTS LIST MODEL# HS4999 IF MISSING PARTS, PLEASE CALL (800) 492-9334 BATTING TEE BALL NET PART H Qty: 1 PART A Qty: 1 PART I Qty: 1 Qty: 1 PART G PART B Qty: 1 Qty: 1 PART K Qty: 29 PART F PART C Qty: 1...
- Page 3 ASSEMBLY INSTRUCTIONS BATTING TEE PART C PART A STEP 1 - Make sure PART A’s bottom is touching ground. In the center hole of PART A (Base), Insert PART C into the three small holes surrounding the center hole on top of base as shown in Figure 1. FIGURE 1 PART B STEP 2 - Turn PART A upside down and insert PART B into the center recess...
- Page 4 ASSEMBLY INSTRUCTIONS BATTING TEE (Cont.) STEP 3 - Screw the STEM (Parts E-G) onto PART B by twisting clockwise until tight, as shown in FIGURE 4. PARTS E-G NOTE: The push pin should align with the back of the BASE when fully tight- ened and allow you to adjust the height of the tee by selecting the various hole positions on the STEM.
- Page 5 ASSEMBLY INSTRUCTIONS BALL NET (Cont.) STEP 1 - Remove net from box and connect pole sections. Once assembled, take each end of pole assembly and place the bullet cap rods into the ground 8-9” to form an arch as shown in image. NOTE: If the ground is hard, hammer a 9 inch screw driver to create a hole, then remove, and insert the pole section into the hole.
- Page 6 - and if adequate repairs cannot be made, DO NOT USE! IF YOU HAVE ANY QUESTIONS REGARDING THE USE OR SAFETY OF THE HITTING STATION #1, CONTACT HEATER SPORTS AT 1-800-492-9334. 95 West 650 South • St. George, UT 84770 • Toll Free: (800) 492-9334 • CustomerService@HeaterSports.com...
Need help?
Do you have a question about the HittingStation 1 and is the answer not in the manual?
Questions and answers