BEFORE YOU BEGIN Keep these instructions for future reference as they contain important information. Adult assembly is required. Tool needed for assembly: long shaft Phillips screwdriver. Batcave™ requires four C (LR14) alkaline batteries 1,5V (not included). For longer life, use alkaline batteries. (LR14) Plan on about 30 minutes for assembly.
INSTALL BATTERIES Loosen the screws in the battery door. Insert four, new C (LR14) alkaline batteries. Replace the battery door and tighten the screws. Do not over-tighten the screws. You may need to reset the electronics if the playset begins to operate erratically.
Page 5
PARTS M3,5 x 1,6 mm CAUTION This package contains small parts. For adult assembly only.
Page 6
ASSEMBLY MAY I BE OF Use your smart device to scan the code. No app required! ASSISTANCE? In camera mode, focus on the code. Then tap the pop-up to watch how to assemble the toy. Or, go to: fisher-price.com/ assembly/GMP48...
Page 11
ASSEMBLY ASSEMBLY Fit the “T” tab on the platform into the “T” slot on the underside of the jail cell. Push to “snap” into place.
Page 12
ASSEMBLY Turn the jail assembly upright to attach it to the suit storage floor.
Page 13
ASSEMBLY Fasten small connector. Fasten large connector. You may need to adjust the two halves of the playset (more open or more closed) to assemble the connector cover.
Page 14
ASSEMBLY Locate all seven screw holes on the connector cover.
Page 15
ASSEMBLY Attach the canopy button holes to the pegs.
Page 16
THIS IS ONE BIG BATCAVE™! The Batcave™ is Secured! Press the Alfred button, turn the suit storage or the jail Power Pads for sound effects and phrases. The news report button lets you know what despicable crimes the villains are up to. Slide power-volume switch Press of any of the six villain buttons once for a short on the back of the playset...
Page 17
STORAGE Fold the Batcave™ open to start fighting crime or closed when the day is saved.
GENERAL INFORMATION CAN ICES-3 (B)/NMB-3 (B) FCC STATEMENT (UNITED STATES ONLY) This device contains licence-exempt transmitter(s)/receiver(s) that This equipment has been tested and comply with Innovation, Science and found to comply with the limits for Economic Development Canada’s a Class B digital device, pursuant licence-exempt RSS(s).