Table of Contents
Advertisement
Quick Links
QXEDGP Series
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations, if
applicable.
• Do not mount near gas or electrical heaters.
• Do not use outdoors.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering by
unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
• Cap unused wires with enclosed wire nuts or other approved method.
• Make sure wire terminations are secure and leads are properly tucked in appropriate wire channels.
• Use caution when servicing batteries.
• Allow battery to charge for 24 hours before first use.
10070253 REV 1 - 09/21
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS!
Technical Support
■ (623) 580-8943 ■ technicalsupport@barronltg.com
1
800-533-3948 www.barronltg.com
Advertisement
Table of Contents
Related Manuals for Exitronix EQUITY LINE QXEDGP Series
Summary of Contents for Exitronix EQUITY LINE QXEDGP Series
- Page 1 QXEDGP Series Installation Instructions IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS. When using electrical equipment, basic safety precautions should always be followed including the following: • DISCONNECT AC POWER SUPPLY BEFORE SERVICING. • Installation and servicing of this equipment should be performed by qualified service personnel only. •...
- Page 2 QXEDGP Series Installation Instructions Installation Instructions Choose mounting configuration (end, top or back mount). Plug remaining holes with the appropriate color plugs. 1. Secure canopy bracket to ceiling or wall. 2. Open the housing cover. 3. Secure housing and canopy with screws (see mounting configuration). 4.
- Page 3 QXEDGP Series Installation Instructions Wiring Diagrams Fig. 4 - Battery-Backup/Self Diagnostic Wiring Fig. 5 - AC-Only Wiring Diagram Diagram Fig. 6 - Dual Circuit Unit Fig. 7 - 208/220/240 Volt (Battery Backup) Fig. 8 - 208/220/240 Volt (AC Only) Fig. 9 - 208/220/240 Volt (Dual Circuit) 10070253 REV 1 - 09/21 800-533-3948 www.barronltg.com...
- Page 4 QXEDGP Series Installation Instructions Self-Test/Self-Diagnostics (G2) Operation The purpose of this option is to provide Self-testing and Self-diagnostic capabilities to the emergency unit. At predetermined intervals, the emergency unit will automatically switch into battery mode. Refer to the Self-Test Feature section below for timing details.
Need help?
Do you have a question about the EQUITY LINE QXEDGP Series and is the answer not in the manual?
Questions and answers