Color Temperature In Dvi Mode - Technicolor - Thomson 42WB02S Service Manual

Digital Voltage meter the negative(+) to get main power board:(GND) PCB pin.
3. Digital Voltage meter the anode(-) to get main power board: (-Vy) CN802 Vy Connect pin.
Adjust VR (-Vy) = -80 ±0.3Vdc
4. Digital Voltage meter the anode(-) to get main power board: (Vset_up) CN802 Vset_up Connect pin.
Adjust VR 105(Vset) = 220 ±0.3Vdc
5. All Voltage: DC(=) 5Vdc , 15Vdc
Vs AD J VR102 Va AD J VR105
PS : Every mode voltage values ar e print on the label in each panel
Color Temperature Adjustment
1.1 Color Temperature setting in DVI Mode
1. Turn on PDP set and warm up for over 30 minutes.
2. Turn on Color Analyzer CA-100 and reset CA-100.
3. Switch PDP input signal source to DVI mode.
4. Set up Video Pattern Generator (Astro, Model= VG-828H).
Timing set = 640 x 480 @ 60Hz;
Video = Panel Link (the DVI output mode)
Connect PDP DVI input connector with Astro to receive DVI signal.
Vset AD J VR104
16
Vy AD J VR103
-
First issue 06 /03