Lumascape Balitza Mini Installation Instructions

Lumascape Lighting Industries Pty Ltd
38-44 Enterprise Street, Cleveland, QLD 4163, Australia
PO Box 1875, Cleveland D.C., QLD 4163, Australia
T 07 3286 2299
F 07 3286 6599
E sales@lumascape.com.au
W www.lumascape.com.au
LS582 & LS592: Balitza Mini & Micro (low voltage)
Warranty voided if not installed as per installation instructions
DANGER
ISOLATE LUMINAIRE FROM POWER
Failure to isolate power
supply before installation or
maintenance may result in
fire, serious injury, electric
shock, death and may
damage the luminaire.

Mark and cast/drill holes

1.
Mark location of fixtures and cable entry/
mounting holes. Refer template over for details.
Drill or cast holes as required.
26.39 mm
mounting point
mounting point

Insert lamp into fixture

4.
Check wattage and insert lamp into fixture.
Test to ensure lamp and fixture is operational.
www.lumascape.com.au
Always check luminaire label to confirm correct supply
voltage, lamp type and wattage
Installations are to comply with local wiring rules
Luminaires can become hot. Use discretion in placement
Do not mount luminaires on combustible surfaces
Do not use power tools to fasten or assemble luminaire
All connections must be kept dry and free from dirt
Do not hose or preassure clean the luminaire
Luminaires and transformers to be installed by licensed
electrical contractors

Open fixture

2.
Loosen all three screws at the base of
the fixture.
Remove lid.
fixture outline
cable entry

Seal fixture

5.
Put lid over the base plate and tighten screws.
Copyright ©2014 Lumascape Lighting Industries Pty. Ltd. ABN 21 010 572 773
INSTALLATION INSTRUCTIONS
WARNING
BOLLARD & PATHWAY
MODEL: LS582 & LS592
INPUT VOLTAGE: 12 V
IMPORTANT
To achieve IP66 rating, use round cable (size 5-10 mm) to
suit entry gland supplied with fixture
Luminaires to be used for intended purpose only
Keep luminaire free of soil, mulch and other loose debree
The luminaire should only be used complete with its
protective shield (cover)
Do not operate the luminaires with a missing
or damaged parts
Use only genuine Lumascape parts to replace damaged
or missing components

Fit mounting plate

3.
Pull cable through gland and tighten. Connect
leads to terminal block and mount base plate
to surface with screws provided. Seal with
silicone glaze.
To achieve IP66 rating,
use round cable (size
5-10 mm) to suit entry gland
supplied with fixture
SILICONE
Use silicone glaze to seal the four
NOTE
SILICONE
screw holes and achieve IP66.
Use silicone glaze to seal
It is the installers responsibility
the gour screw holes and
to achieve an adequate seal
achieve IP66.
against the mounting surface so that
no water can enter the luminaire

RELAMPING

1. Open fixture as shown in step 2.
2. Remove old lamp from fixture as shown below.
3. Insert lamp into fixture as shown in step 4.
4. Seal fixture as shown in step 5.
A.C.N. 0105 72 773
IN0084 - 27 June 2014