JVC KD-DV6206 Installation And Connection Manual page 4

D
Required connections for DVD playback
KS-HP2
Cordless headphones
* 4
(not supplied)
E
Connecting the external amplifiers and/or subwoofer
You can connect amplifiers to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
• For amplifier only:
– Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
– The line output level of this unit is kept high to maintain the hi-fi sounds reproduced from this unit.
When connecting an external amplifier to this unit, turn down the gain control on the external amplifier to obtain the best performance from this unit.
Rear speakers
JVC Amplifier
Front speakers
JVC Amplifier
F
Connecting the external components
®
CD changer, Apple iPod , or JVC D. player
• Set "CHANGER" for the external input setting (See page 36 of the INSTRUCTIONS.)
You can connect these components as illustrated below. The iPod
CAUTION :
• Before connecting the external components, make sure that the unit is turned off.
CD changer jack
* 7 iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.
Other external component
or
RCA Pin plugs
When using JVC's KV-MR9010 and KS-HP2,
Rear side
connect using a conversioncable of this type
(not supplied).
Headphones (not supplied)
KV-MR9010
9-INCH WIDESCREEN MONITOR
(not supplied)
Remote lead
Remote lead (Blue with white stripe)
7 or D. player can be connected using an interface adapter (not supplied)—KS-PD100 (for iPod) or KS-PD500 (for D. player).
*
JVC CD changer
Video cord (not supplied)
Stereo mini plug
* 4
Digital optical cable (not supplied)
Audio/video control amplifier or the decoder
compatible with the multichannel digital sources
Y-connector (not supplied for this unit)
To the remote lead of other equipment or auto antenna if any
JVC Amplifier
Front speakers
* 5 Signal cord (not supplied for this unit)
* 6 Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place
uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do
so may cause damage to the unit.
or
* 8 Connecting cord supplied for your CD changer
External component
4
DIGITAL OUT
See "About sounds reproduced
through the rear terminals."
* 4
To listen to disc playback sound while in Dual Zone
operations (see page 32 of INSTRUCTIONS).
Subwoofer
Apple iPod (separately purchased)
JVC D. player (separately purchased)
9
* Signal cord (not supplied for this unit)