Advertisement
FIBONACCI KNX
Installation Manual
Installation
1. Mounting height
The recommended mounting height for Fibonacci is 1450mm-1650mm (57"- 65") above the finished floor.
2. Rough-In
Use a standard European back box or a 1-gang US wall box. The included mountin bracket should be
attached with the included screws.
3. Installing Fibonacci on the wall
Position Fibonacci for portrait mounting (the orientation can be set in the ETS parameters), align the mounting
bracket hooks with the Fibonacci mounting slots and gently press it towards the mounting bracket/wall.
Fibonacci snaps in when pushed to its mounting bracket.
Powering up Fibonacci
Installation and commissioning
Connect Fibonacci to the KNX bus according to the KNX guidelines.
Load the physical address into the Fibonacci from ETS via the KNX bus.
Commission Fibonacci using ETS and load the configuration into the device
Please refer to the software manual to configure Fibonacci.
Removing Fibonacci
Follow the step 1 and 2 in order to remove Fibonacci from the wall.
1
Top of
single-gang box
Dry wall
Technical data
Current consumption KNX bus: 30mA
Ambient temperature: Operations -5-45°C
Max. humidity: 93% relative humidity no moisture condensation
Protection Class: II
Type of protection: IP20
Certification: CE
basalte bv | hundelgemsesteenweg 1A | 9820 merelbeke | belgium
t +32 (0)9 385 78 38 | f +32 (0)9 329 66 95 | www.basalte.be | info@basalte.be
2
Mounting
bracket
Push
Pull
Storage & Transport -15-55°C
Advertisement
