Regency Kee Post MTBP27 Instructions

Table legs

You will need a Phillips Head Screw Driver and a Tape Measure to Assemble.

Hardware :

A: Screws(24)

B: Legs(4)

STEP 1 (Square Table Top): Place Table Top(C) on a clean flat surface with desired table finish face down. Position

assembled legs as shown in Figure A.

Then, attach assembled Legs to Table Top using 6 Screws(A) per Leg.

IMPORTANT NOTICE:

• Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching the parts.

• Check to be sure that you have all parts and hardware.

• Remove all wrapping materials, including staples & packing straps before you start to assemble.

• Keep all hardware parts and packaging out of reach of children.

MTBP27

Kee Post Table Legs INSTRUCTIONS

You will need 2 people for this assembly.

C: Table Top (may vary)

Any problems or questions call Regency Office Furniture at 1-866-816-9822

Figure A

Table of Contents

Do you have a question about the Kee Post MTBP27 and is the answer not in the manual?

Page 1 • Check to be sure that you have all parts and hardware. • Remove all wrapping materials, including staples & packing straps before you start to assemble. • Keep all hardware parts and packaging out of reach of children. Any problems or questions call Regency Office Furniture at 1-866-816-9822...
Page 2 Position assembled legs as shown in Figure C. Then, attach assembled Legs to Table Top using 6 Screws(A) per Leg. Figure C STEP 2: Using 2 people, flip the table over and adjust leveling glides accordingly. Any problems or questions call Regency Office Furniture at 1-866-816-9822...