Regency Mia 2000 Instructions

Hardware :

A: Large Bolts (4) • B: Medium Bolts (4) • C: Small Bolts (2) • D: Inserts (4) • L: Allen Key • M: Dowels (8)

E: Back Frame F: Seat Frame • G: Wood Frame (2) H: Cross Bars (2) I: Back Cushion J: Seat Cushion

K: Fabric Cover

STEP 1 : Connect the Back Frame(E) to the Seat Frame(F) by using 2 Small Bolts(C).

IMPORTANT NOTICE:

● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.

● Check to be sure that you have all parts and hardware.

● Remove all wrapping materials, including staples & packing straps before you start to assemble.

● Do not tighten all screws/bolts until completely assembled.

● Keep all hardware parts out of reach of children.

Instructions for the Mia #2000

Any problems or questions call Regency Office Furniture at 1-866-816-9822

Table of Contents

Do you have a question about the Mia 2000 and is the answer not in the manual?

Page 1 ● Remove all wrapping materials, including staples & packing straps before you start to assemble. ● Do not tighten all screws/bolts until completely assembled. ● Keep all hardware parts out of reach of children. Any problems or questions call Regency Office Furniture at 1-866-816-9822...
Page 2 Instructions for the Mia #2000 STEP 2 : Place the Metal Frame down with the curved side of the headrest facing up. Place the Back Cushion(I) and Seat Cushion(J) on top of the frame as shown below. Then slide the Fabric Cover(K) over the Frame and Cushions so the opening of the fabric cover is under the Seat Frame.
Page 3 Metal Frame with Fabric Cover within the legs of the Wood Frame in preparation to attach the two together with 4 Medium Bolts(B). Once you have the holes aligned attach the Metal Frame to the Wood Frame as the image shows below. Ensure the curvature of the headrest faces the user. Any problems or questions call Regency Office Furniture at 1-866-816-9822...