LONEALERT Pro ATEX Instruction Manual

LONEALERT User Guides
To download digital versions of our user guides,
either scan the QR code above, or head to:
https://www.lonealert.co.uk/lonealert-user-guides/
www.LONEALERT.co.uk
+44 (0)330 999 8484
Document Reference: 537-2001 - Protector Pro ATEX Complete Guide
The Protector Pro ATEX is fully customisable - to change any settings, speak to your LONEALERT champion.
Please note: GPS location can take a few minutes to find you when you power
your Protector Pro ATEX up for the very first time. We suggest that before
use, you place it close to an external window or wear it outside for around 30
minutes.
Step 1) Open the SIM card slot
Ensure that the Protector Pro ATEX is powered off
and lay it face up in front of you.
At the bottom left side of the device, there is a
rubber cover - lift this up from the bottom to reveal
the SIM card slot.
Step 2) Insert the SIM card
Pop out the micro SIM card found within the box
and place it in the Protector Pro ATEX. On the back
of the Protector Pro ATEX is an image showing the
correct way of entering the SIM card - please ensure
this is followed correctly, otherwise the SIM will not
be read by the device.
Step 3) Closing the SIM card slot
Fold the rubber cover back over the slot and ensure
it is pressed in until it is flat and not sticking out.
Initial Protector Pro ATEX setup
Protector Pro ATEX Instruction Guide
Speaker
Display
Call/Answer
Set timer Check
Call service
Microphone
Sim Card Slot
530-0000
Step 4) Check the Protector Pro ATEX
Power on the Protector Pro ATEX using the red
end call button.
After a short while, a mobile network should
appear on-screen. If an image of a SIM card
appears with a question mark, the SIM may not be
installed correctly. Once you have a mobile
network on screen, check that the timer function
works on the device by pressing the green call
button.
(For more information on how to use timers,
view the next page.)
Step 5) Covering the SIM card slot
In the LONEALERT device box, you will find a
small black sticker. Remove this and place it over
the SIM card slot on top of the rubber cover.
Ensure that it sticks and is flat, as this helps to
keep the SIM card slot free from dust.
Strap hole
SOS button
Power/End Call
Cancel timer
Turn man
down function
on/off
(Disabled by
default)