Window Frame And Glass; Side Door - Reliant ROBIN 850 Workshop Manual

The body Section 0
7 Replace in reverse order. After fitting the
external handle to the door. the plunger screw
(adjuster screw) should be adjusted to give a
clearance of 1 ·58mm (0·063in) between the
plunger and lock thrust plate.
Adjustment of door striker plate
3 Retighten striker plate retaining screws and
then check that door lock mechanism makes a
good seating on the catch.
Window frame and glass
To remove (see Figure 2)
2
1 Slacken the two striker plate retaining
screws. DO NOT remove the screws. otherwise
the catch of the striker plate will fall between
the inner and outer body.
1 Remove door casing. regulator mechanism
and door lock mechanism. as previously described.
2 Remove the waterproof sheet completely
from the door.
2 Adjust the striker plate (elongated holes in
the body facilitate this) until the door is flush
with the body.
3 With the window fully closed prise the silent
channel from the bottom of the window frame
to gain access to the lower frame retaining
rivets.
Figure 2 Side door shell and trim
1 Side door
2 Drop glass
3 Frame
4 Silent channel
5 Rivet. frame to door
6 Weatherstrip, Inner
7 Rivet. weatherstrip to door
8 Weatherstrip outer
9 Rivet. weatherstrip to door
10 Channel regulator
11 Insulation. drop glass
12 Casing board
13 Tapit fming
14 Hinge assembly, upper
15 Hingo assembly, lower
16 Set screw . hinge to body
17 Washer. hinge to body
18 Lockwasher. hinge to door
1 9 Set screw. hinge to door
20 Lockwasher. hinge to door
21 Backing plate. hinge
22 Support plate. hinge
23 Set screw. support plate to body
24 Coachwasher. support plate to body
25 Lockwasher. support plate to body
26 Set screw. support plate to hinge
27 Coachwasher. support plate to hinge
28 Lockwasher. support plate to hinge
29 Nut. support plate to hingo
30 Backing plate. hinge
31 Backing plate. hinge
32 Rivet. plate to body
33 Waterproof panel
34 Tape. waterproof panel
35 Pad. door link
36 Weatherstnp. door aperture