Advertisement
X"
Power Connector (20/2 Gauge Plenum Rated Wire)
LLED8200-PC-PLM-X
(X = Specify Length, 36" Standard)
CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | info@calilighting.com | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
2020.5.11 Rev 0
CONTINUOUS RUNS
1.
Insert terminal connectors into each terminal where two LED boards will be joined.
Push boards together leaving no gap.
Note: Ensure + and - terminals are aligned throughout the entire run.
Terminal Connector
Connected Boards
No gap between boards
This document is issued in strict confidence on condition that it
is not used as a basis for manufacture or sale and is not copied,
reprinted, or disclosed to a third party either wholly or in part
without the prior written consent of California Accent Lighting, Inc.
LLED8200-PC-PLM
CONNECTORS
1.
Insert power connector or continuous connector lead wires into LED board terminals.
Insert the positive wire (red) into the terminal marked "+". Insert the neutral wire (black)
into the terminal marked "-".
Note: Ensure + and - terminals are aligned throughout the entire run.
Terminals
Power Connector or
Continuous Connector
lipLEDs
Page 2 of 2
SOLDERING
Installed connector
™
Advertisement
