exacqVision S Series Standard Quick Start

1

Hardware Overview and Installation

3
Item # Description
1 LCD Display Panel
2 Hard Drives
3 Power Button
4 Power Cable
5 VGA Monitor
6 Network Cable
7 USB Keyboard
*Monitor and keyboard not included. It is recommended that you connect a monitor and keyboard to the S-Series system when
necessary to change the system configuration. However, an S-Series system can also be configured remotely using an SSH Client
(such as PuTTY, which is available for free on the Internet). The configuration menus should appear the same way whether you
are interacting with the system directly or through an SSH Client.
**S-Series systems are configured for network bonding with failover. If a connection is not found on the ETH1 port, the system
automatically tries to connect using the ETH2 port.
www.exacq.com
S-Series Standard Quick Start
Notes
Cycles through information, including the IP address of the system
Insert the drives in the correct order, as shown on the label on top of the system
Connect the power cable on the rear panel before pressing the power button
IMPORTANT: See "exacqVision System Safety Instructions" before connecting
Not included*
Connect one or two network cables**
Not included*
+1.317.845.5710 USA (Corporate Headquarters)
+44.1438.310163 Europe/Middle East/Asia
1
2
4
5
6
7
Page 1 of 3
6/27/2013