Table of Contents
Advertisement
2-3.
Precaution on Replacing the VC-1038 Board
The board for repair is not recorded the information peculiar to a model. Therefore the following data are needed to
write.
Note
The [LOAD AND WRITE] function in "ADJUSTMENT DATA BACKUP" on the DATA tab in the Adjust Manual
overwrites all data of the unit. Therefore execute the [LOAD AND WRITE] before performing the following operation.
2-3-1.
Destination Data
The destination data stored in the repairing board is different from the destination setting stored in the board before
replacement in some cases.
When the board has been replaced with a repairing board, be sure to set the destination.
Method of the destination data write:
Start the Adjust Manual in the Adjust Station and execute the "Destination data write" on the ADJUST tab.
2-3-2.
USB Serial Save
When you replace to the repairing board, get the USB serial number from the former one.
Method of the USB serial save:
Start the Adjust Manual in the Adjust Station and execute the "USB serial save" on the DATA tab.
2-3-3.
USB Serial No. and Product ID
The unit is shipped after an ID (USB Serial No.) unique to each unit and an ID (Product ID) unique to each model have
been written.
These IDs have not been written in a new repairing board. Therefore, after the board has been replaced, be sure to write
these IDs to a new repairing board.
Method of the ID writing:
Start the Adjust Manual in the Adjust Station and execute the "PRODUCT ID & USB SERIAL No. INPUT" on
the ADJUST tab.
2-3-4.
Restore Data (Projector Model)
Before replacing the board with a repairing board, be sure to extract the following data from the former one.
• Fixed value (that shows irradiation performance of the projector)
• Serial number of the projector unit
Method of the data extracting:
Start the Adjust Manual in the Adjust Station and execute the "Projector Data Reference" on the DATA tab.
FDR-AX30/FDR-AX33/FDR-AXP33/FDR-AXP35
2-3
Advertisement
Table of Contents
