Table of Contents
Advertisement
Mounting the Speakers
1 Use the included template with a rotary tool or jigsaw to cut the hole for the speaker.
2 Connect the speaker wires while observing polarity
3 Apply marine sealant on the speaker and the mounting surface.
4 Place the speaker in the cutout.
5 Using a #2 Phillips screwdriver, turn the screws
mounting surface.
Although you may use a power screwdriver to initially turn the screws on the mounting tabs, you must use a
torque screwdriver to complete the installation. Using power tools to fully tighten the screws can damage the
speaker housing and make it difficult to install the speaker grille.
6 Using a torque screwdriver, tighten the screws by hand to 1.0 Nm (0.74 lbf-ft) on the FM-F65/F77 speaker
models or 1.5 Nm (1.11 lbf-ft) on the FM-S10 subwoofer models.
7 With the speaker mounted, place the grille onto the speaker, and push to secure it.
Flush Mount Series Installation Instructions
(Speaker Wiring, page
4).
to extend the mounting tabs
NOTICE
lightly hold the speaker to
3
Advertisement
Table of Contents
