CE-Conformity Declaration Product: Mortiser 719A Stock Number: 1791263M 719AS Stock Number: 708572KM Brand: JET Manufacturer: Walter Meier (Tool) AG, Tämperlistrasse 5, CH-8117 Fällanden, Switzerland On our own responsibility we hereby declare that this product complies with the regulations * 2006/42/EC...
Page 3
Dear Customer, Many thanks for the confidence you have shown in us with the purchase of your new JET-machine. This manual has been prepared for the owner and operators of a JET 719-A mortiser to promote safety during installation, operation and maintenance procedures.
Page 4
Remove all loose clothing and confine Specifications regarding the maximum 4.2 Noise emission long hair. or minimum size of the workpiece must Acoustic pressure level (EN 11202): be observed. Idling 67,8 dB (A) Before operating the machine, remove tie, rings, watches, other jewellery, and Do not remove chips and workpiece In operation 77,5 dB (A)
Page 5
5.5 Starting operation NOTE: You can start the machine with the The rate of feed must be fast enough green on button. The red button on the to prevent burning at the tip of the drill main switch stops the machine. bit, but not so fast as to cause the machine to stall.
Page 6
Tighten the screw (2, Fig5) just enough Defective safety devices must be to hold the chisel (4, Fig5) in place. replaced immediately. Using bits with shorter shanks: It will be necessary to attach the Repair and maintenance work on the electrical system may only be carried spindle extension.