GE Profile JSP47WFWW Dimensions

TM TM
JSP47BF/CF/WF – GE Profile
Dimensions (in inches)
24
31-1/4
2-7/8"
To Front
Surface Of
Countertop
20-5/8" Door
Clearance
From Front
Surface of
Countertop
27-1/2
KW Rating
240V 11.6
208V 8.7
Breaker Size
240V 40 Amps
208V 40 Amps
Specification Revised 11/03
220438
™ 30" Slide-In Electric Range
Accessory
Backguard
30 " Min .
6" Min.
From Walls
4
30 " Min .
23-3/16
36
2-1/2
30
If you are NOT using the
optional Filler or Backguard:
23-3/16
30
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Listed by
Underwriters
Laboratories
R
Note: Cabinets installed adjacent to slide-in electric ranges must have an adhesion spec
of at least 194°F temperature rating.
Note: All 30" Slide-In Ranges conform to U.L. requirements for 0" spacing from range to
adjacent walls below countertop. To reduce possibility of scorching the side walls above the
Shave Raised Edge To Clear
31-1/8" Wide Control Panel
countertop when no load is present on burners, it is recommended that a minimum 6" spacing
from adjacent side wall be allowed for possible extended high-heat element operation.
9/16
Receptacle Locations: For all 30" Slide-In Ranges locally approved flexible service cord
or conduit must be used because terminals are not accessible after range installation. See
shaded area in drawing for location of electrical outlet box. Recommended outlet locations
allow range to be installed directly against rear wall.
Acceptable
Electrical
13" Max.
Optional Kits for Slide-In Electric Ranges (Available at additional costs)
Outlet Area
15" Min.
Accessory Backguards
(Attaches to the back of
25
range as a backguard when
unit is installed in
30" free-standing cutout)
JXS37WW – White
7-1/2
JXS37CC – Bisque
JXS37BB – Black/Stainless
2-1/2
If you are using the
optional Filler or Backguard:
25
30
Installation Information: Before installing, consult installation instructions packed
with product for current dimensional data.
For answers to your Monogram,
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center
Body Sides Optional Lower Trim Kits
(Slide-in ranges are sold (If counter height is greater
than 36.5", a lower trim kit
without sides installed. Can
is recommended to extend
be installed on either left
the useful height to 38"
or right when unit has one
maximum)
exposed side [no cabinet
JXS56WW – White
adjacent]. Kit contains
JXS56CC – Bisque
1 body side)
JXS56BB – Black
JXS76WW – White
JXS76CC – Bisque
Optional Top Filler Kits
JXS76BB – Black
JXS66WW – White
Vertical Side Trim Kits JXS66CC – Bisque
(If cabinet cutout width is JXS66BB – Black
more than 30", a vertical
side trim kit may be used to
close the gap between the
range and cabinet)
JXS86WW – White
JXS86CC – Bisque
JXS86BB – Black
® GE Profile ™ or
® service, 800.626.2000.