TP-Link TL-WR740N Quick Installation Manual page 4

Hide thumbs Also See for TL-WR740N:

English

How do I restore my Router's configuration to its factory default

settings?

With the Router powered

on, press and hold the

RESET button on the rear

panel for 8 to 10 seconds

before releasing it.

Press it for 8 to 10 seconds

Once the Router is reset, the current configuration settings will be lost

Note

and you will need to re-configure the Router.

What can I do if I can not access the Internet?

Check to see if all the connectors are connected well, including the

telephone line (for your modem), Ethernet cables and power adapter.

Make sure that you are connected to the TP-LINK Router with the

computer that was originally connected to your modem, then log on to the

web-based management page and browse to "Network > MAC Clone",

click "Clone MAC Address" and then click "Save". Reboot the Router

and try to access the Internet from your computer, if the problem persists,

please go to the next step.

Log on to the web-based management page and browse to "Network >

LAN", change the default LAN IP address from 192.168.1.1 to 192.168.x.1

(x can be any number from 2 to 254) to avoid an IP conflict with your

Modem, click the "Save" button; the Router will then reboot and you may

try to access the Internet from your computer. Please note that the Router

can only be accessed using the new LAN IP address (192.168.x.1).

Table of Contents