Klarstein STUDIO 10 ARC Manual page 27

Notes on the adjustable temperature range
• The temperature range can be set to OFF or between 10-30 °C. At OFF the heating
is switched off. At 10-30 °C it can be set from when the heating heats.
• When ON, the heater heats continuously. As soon as the temperature is set higher
than the room temperature, the heater starts heating, even if it is a weekly program.
• To start the temperature setting quickly, simply press the arrow keys (B) or (C) on the
display.
Adjust brightness (D)
The brightness control is used to select the desired flame brightness.
Press the brightness key (D) to start the brightness setting. Press
the arrow keys (B) or (C) to select the desired brightness level.
The default brightness level is 3. The brightest setting is 5 and is
displayed on the screen as shown on the left.
Set runtime (E)
Press the (E) key to start the timer setting. Press the arrow keys (B)
or (C) to set the run time as follows: 00-30-1H-2H-3H-4H-5H-
6H-7H-8H-9H. The display [00] means no timer. The display [30]
means 30 minutes.
Switching between Celsius and Fahrenheit (F)
The default temperature display is Celsius. Press the (F) key for 3 seconds, then press the
(B) or (C) arrow keys to change the temperature display from Celsius to Fahrenheit.
Key lock (C)
Press and hold the brightness key (D) for more than 6 seconds
to lock or unlock the keys. Once the keys are locked, [LOC]
flashes in the display for 6 seconds and then disappears. Press the
brightness key (D) again for 6 seconds to unlock the keys.
Note: This function can only be set on the control panel.
EN
27