Matco Tools RL214 Operating Instructions Manual page 6

Troubleshooting for the Head of
the Rivet Gun
1. Make sure that there is no air flow going
to the Rivet Gun
2. Use the spanner to remove the head
from the frame. (Fig. 1)
3. Use the spanner to remove the Jaw
Housing, Jaws, Jaw Pusher, and the
Pusher Spring. (Fig. 2)
4. Thoroughly clean the inside of the Frame
Head. (Fig. 3)
5. Use a light gauge machine oil to
lubricate the parts shown in figure 4.
6. Re-assemble the Rivet Gun and check the
length of the Rivet Gun Head by using
the spanner as shown in figure 5.
RL214 - 6 -
Fig. 1
Fig. 2
Fig. 3 Fig. 3
Fig. 4 Fig. 4 Fig. 4
Fig. 5 Fig. 5
Rev. 4/12/01