GE JP626CFCC Dimensions And Installation Information

GE Appliances
JP626WF/CF/BJ – GE
®
Counter Installation (in inches)
13" MAX.
depth
30" MIN. to
unprotected
18" MIN.
cabinet
to cabinet
C to
rear wall
L MIN.
clearance to
side wall
from cut-out
Electrical junction box 16" MIN.
below countertop
Dimensions (in inches)
Overall Cutout
W D H A
35-1/2 21 3 33-7/8 19-1/8
Specification Created 1/04
321343
36" Built-In Electric Cooktop
Cooktop Dimensions (in inches)
W
Cooktop
R MIN.
A
clearance to
side wall
from cut-out
F
(min.)
Cut should
not interfere
with cabinet
structure at front
To Edge
Minimum Spacing of Front
To Nearest Counter
Combustible Wall (Min.)
B C R L
2-1/2 3-3/4 3-3/4 2-1/2
KW Rating
240V
D
208V
H
Breaker Size
240V
208V
B
† Note: Check local codes for required breaker size
Built-In Electric Cooktops
Required free area between the bottom of the cooktop and any combustible
material, i.e., shelving is 5" minimum. Free area not required when installing
wall oven underneath. Requires an 18" minimum from cooktop to adjacent
overhead cabinets. Units are furnished with a 48" flexible armored cable.
JP626BJ is approved for use over GE 30" Single Wall Ovens only. Refer to
cooktop and wall oven installation instructions packed with product for
current dimensional data.
Note: If installed with a GE Telescopic Downdraft System, consult both cooktop
and downdraft installation instructions packed with product before installing.
Cooktop gas/electric supply may need to be re-routed to install downdraft.
Note: The countertop must be at least 26" deep with a flat surface area of 23-1/2" or
more, front to back. In addition, other clearances to the front edge of the countertop
must be considered.
Installation Information:
Before installing, consult installation instructions packed with product for current
F
dimensional data.
R
7.4
5.6
40 Amps
†
40 Amps
†
For answers to your Monogram,
GE appliance questions, visit our website at
®
Listed by
Underwriters
GEAppliances.com or call
Laboratories
GE Answer Center service, 800.626.2000.
®
® GE Profile ™ or