Summary of Contents for Northern Industrial Flux Core 125
Page 1
QUICK SET-UP GUIDE This guide is intended to provide quick instructions on the set-up of your new welder. Please take time to review the operator’s manual prior to operating this unit. Flux Core 125 Item #628575 For more help visit www.ntwelderhelp.com...
Page 2
INSTALLING UNIT HANDLE INSTALLING A 4” SPOOL OF WIRE Tighten Clockwise Remove wing nut, washer and black bushing. Slide on spool so The handle for this unit is supplied along with the hardware to wire feeds off the bottom of spool. Reinstall bushing, washer and secure it.
Page 3
INSTALLING A 8” SPOOL OF WIRE DRIVE ROLL REMOVAL Drive Knob Roll 8 In. Drive Spool Roll Adapter Remove wing nut, washer and black bushing. Slide on spool This unit comes with the drive roll in place. If removal is needed, adapter.
Page 4
ADJUSTING DRIVE ROLL TENSION SETTING FRONT PANEL CONTROLS Voltage Control Wire Feed Control On the wire compartment access panel is a set-up guide. Find the Test drive roll tension by feeding wire into a gloved hand from type of material being welded and the size of wire you are using. about 4 inches away.
Need help?
Do you have a question about the Flux Core 125 and is the answer not in the manual?
Questions and answers