Drawer; Oven Light Replacement; Racks - GE JGB800DEP Owner's Manual & Installation Instructions

Care and cleaning of the range.
Wire cover holder.
The storage drawer may be removed for
cleaning under the range.
38
Oven Racks and Drawer Racks
If your oven is equipped with nickel oven
racks, they should be removed from the oven
before beginning the self-clean cycle.
To clean the nickel racks, use an abrasive
cleanser. After cleaning, rinse the racks
with clean water and dry with a clean cloth.
If the racks ever become hard to slide, wipe
the rack edges or oven rack supports with
vegetable oil.
If your oven is equipped with gray
porcelain-coated racks, they may be cleaned
in the oven during the self-clean cycle.

Oven Light Replacement

CAUTION:
Before replacing your
oven light bulb, disconnect the electrical power
to the range at the main fuse or circuit breaker
panel. Be sure to let the light cover and bulb
cool completely.
The oven light bulb is covered with a
removable glass cover that is held in place
with a bail-shaped wire. Remove the oven
door, if desired, to reach cover easily.
To remove:
Hold a hand under the cover so it
doesn't fall when released. With fingers
of the same hand, firmly push back the
wire cover holder. Lift off the cover.
Do not remove any screws to remove
the cover.
Removable Storage Drawer
The storage drawer is a good place to store
cookware and bakeware. Do not store plastics
and flammable material in the drawer.
The storage drawer may be removed
for cleaning under the range. Clean the
storage drawer with a damp cloth or sponge.
Never use harsh abrasives or scouring pads.
They may also be cleaned by using
an abrasive cleanser. After cleaning, rinse
the racks with clean water and dry with
a clean cloth. If the racks ever become hard
to slide, wipe the rack edges or oven shelf
supports with vegetable oil.
Do not touch hot bulb with a wet cloth.
Replace bulb with a 40-watt household
appliance bulb.
To replace cover:
Place it into the groove of the light
receptacle. Pull the wire forward to the
center of the cover until it snaps into
place. When in place, the wire holds the
cover firmly. Be certain the wire is in the
depression in the center of the cover.
Connect electrical power to the range.
(on some models)
To remove storage drawer:
Pull drawer straight out until it stops.
Tilt the front of the drawer up and free
of the range.
To replace storage drawer:
Set the stops on the back of the drawer
over the stops in the range.
Slide drawer evenly and straight back,
so that the rails in the range are
engaged.