Nailor MAC-700 Installation Operation & Maintenance page 12

INSTALLATION INSTRUCTIONS:
The NBPI is located downstream of the HEPA filter where it makes the particles to become larger and are more easily filtered
from the air. Follow the below steps for installation.
1. Turn off the unit with the ON / OFF switch located on the back of the unit.
2. Mount the NBPI on the brackets using the magnets provided with the unit.
3. Make sure there is 2" (51) clearance from wires or other metal objects.
4. Install the GPS-FC24-AC so that airflow is passing by both emitters at the same time.
CLEANING CYCLE:
NBPI is a self-cleaning device designed to clean the brushed every three days. However, you have the option to change the
cleaning cycle by following the below steps
5. Press the cleaning cycle button once.
6. While cleaning is in progress press and hold the cleaning cycle button for 5 seconds.
7. After LED light started flashing; pressing the cleaning cycle button again will change the days between cleaning.
8. The number of flashes indicates the cleaning interval in days (3 flashes = 3 days, 5 flashes = 5 days).
CAUTION! NEVER TOUCH BRUSHES WHILE OPERATING, SHOCK MAY OCCUR.
TROUBLESHOOTING:
The NBPI is located downstream of the HEPA filter where it makes the particles to become larger and are more easily filtered
from the air. Follow the below steps for troubleshooting.
• If the unit is not working and LED not illuminated:
a. Check the input voltage. Make sure proper voltage is applied to each terminal.
• If wiper sticks on emitters or does not clean or contact emitters:
a. Adjust height of emitters: Loosen screw at base of emitter, gently push or pull emitter to a height where wiper just contacts
emitter. Hold the emitter in place and tighten screw. Verify correct height after tightening screw.
• If unit does not operate properly after verifying the above instructions, please contact Nailor for additional assistance.
Electrical listings: UL, cUL
Approval: UL 867, OSHPD Seismic (OSP), IAQP, CE
Page 12 of 14
Nailor Industries Inc. reserves the right to change any information concerning product or specification without notice or obligation. Nailor Industries Inc. reserves the right to change any information concerning product or specification without notice or obligation.
BIPOLAR IONIZATION
4/21 IOM-MAC-700-INST