Setting Up The Appliance With A Browser; Step 1: Connecting The Appliance To A Network - LogLogic MX Series Quick Start Manual

C
Setting Up the LogLogic Appliance
The LogLogic Quick Start Guide provides simple instructions for quickly getting started
with a new Appliance.
After you install the new LogLogic Appliance in its rack and it has power, set it up as
described in this chapter.
You can set up the Appliance either using the user interface via a web browser, or using
the command line interface via a console connection:


Once the Appliance is running, you want to configure it for your specific needs. For more
information, see the LogLogic Users Guide or LogLogic Administration Guide.
To upgrade an existing Appliance, see the LogLogic Upgrade Guide.

Setting Up the Appliance with a Browser

To set up a LogLogic Appliance using the browser:

Step 1: Connecting the Appliance to a Network

Connect the Appliance to a network where you can access a 10.0.0.x network address
using a class "C" subnet mask (255.255.255.0). You can also connect to the Appliance via
an Ethernet crossover cable.
Note:
network because that is the only port configured on the Appliance by default at startup. The other
ports will work unless the Eth0 port is connected to the network.
Quick Start Guide
All manuals and user guides at all-guides.com
1
HAPTER
Setting Up the Appliance with a Browser . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Setting Up the Appliance using the Console . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Step 1: Connecting the Appliance to a Network

Step 2: Logging in to the Appliance

Step 3: Configuring Log Source Auto-Identification

Step 4: Configuring Network Settings

Step 5: Setting the Time Zone and Time

The Appliance's Default IP Address is 10.0.0.11. The Eth0 port needs to be connected to the
on page 9
on page 10
on page 10
on page 10
on page 11
9