Advertisement
R
T
EQUIRED
OOLS FOR
None
A
I
SSEMBLY
NSTRUCTIONS
The main components of the Mini-Vacuum System are shipped in a fully assembled
condition. All the suction hose sections are equipped with locking, quick-connect
couplings. When assembling the hose sections, make sure the locking tabs snap into
place to make a secure connection. It is not recommended that more than three sections
of hose (approximately 100") be used at a time. This will decrease the performance of
the system. Refer to the Tool Check-out & Assembly part of the Operating Instructions
for the assembly sequence.
T
D
OOL
ELIVERY
The Mini-Vacuum System comes with a handrail mounted hoist for manual lifting and
lowering of the system in the water. Standard Master-Lee J-Lock poles are used to
control assorted vacuum wands and nozzles for an effective underwater cleaning
campaign.
O
I
PERATING
CAUTION:
MLEP Mini-Vacuume System must always be operated in a vertical position.
Running the Pump/Motor in air for more than 10 seconds may cause permanent
damage.
Large items greater than 1/2" diameter, or a length which prevents that material
from passing through a bend in the hose, should be vacuumed using a screened
nozzle or removed in another manner.
1.0 TOOL CHECK-OUTS & ASSEMBLY:
1.1 Ensure tool is configured properly and that all fasteners are securely tightened.
1.2 Install Pump and Motor Assembly into Pump housing. The Pump and Motor
Assembly should be fully seated on the flange O-ring and should hang plumb.
Mini-Vac Assembly Instructions & Users Manual
A
SSEMBLY
NSTRUCTIONS
5
Advertisement
